Introduction

The AquaBliss Shower Filter is designed for easy, tool-free installation on most standard shower systems. With its universal fittings, you can set up your filter in just a few minutes to start enjoying cleaner, healthier shower water. This guide will walk you through the installation process and provide additional information about using the optional angled adapter for tight spaces.

Before You Begin

• Ensure your shower is turned off and water flow is stopped.
• Gather your AquaBliss Shower Filter and the replaceable filter cartridge.
• If your shower connector is positioned very close to the wall, you may need the AquaBliss Angled Adapter for a proper fit.

Step-by-Step Installation

Step 1: Remove the Existing Shower Head

• Unscrew your shower head from the shower arm by hand.
• If it’s too tight, use a soft cloth and adjustable wrench to avoid scratching the finish.

Step 2: Attach the AquaBliss Shower Filter

• Check that the rubber washer is seated properly inside the filter connection.
• Screw the AquaBliss Shower Filter directly onto the shower arm by hand until secure.
• Do not overtighten—hand tightening is sufficient to create a seal.

Step 3: Install the Shower Head

• Attach your shower head to the bottom end of the AquaBliss Shower Filter.
• Again, tighten by hand until snug.

Step 4: Flush the Filter

• Turn on the water and let it run for 1–2 minutes to flush out any loose carbon particles.
• Once the water runs clear, your shower filter is ready to use.

Using the AquaBliss Angled Adapter

If your hand shower connector is too close to the wall, the chrome-plated angled adapter makes installation possible by creating the necessary clearance for your AquaBliss Shower Filter.

Features & Benefits

• Allows installation of a shower filter on a narrow wall connection.
• Protects threads and seals from strain or damage.
• Made of sturdy, corrosion-resistant chrome-plated metal with a 45° angle.
• Maintains optimal water flow while providing a durable, secure fit.
• Compatible with most standard ½’’ shower connections.

How to Install the Angled Adapter

1. Screw the angled adapter onto your existing shower arm by hand.
2. Attach the AquaBliss Shower Filter to the angled adapter.
3. Reconnect your shower head to the bottom of the filter.
4. Flush the system as described in Step 4 above.

Maintenance & Cartridge Replacement

• The AquaBliss filter cartridge lasts up to 12 months under normal use.
• When water flow decreases or every 12 months, replace the cartridge with a new AquaBliss Revitalizing Shower Filter Cartridge.
• Cartridge replacement takes only a few minutes and requires no tools.